The license plate mount is located above the bumper and includes an LED plate light. Up to a 37-inch spare tire mounted on the OEM carrier will fit above the bumper. To keep full visibility of the third brake light with a 37" spare, use our third brake light extension.
Two 3-inch flush mount pod lights can be installed towards either side of the bumper to provide supplemental trail lighting. Alternatively, they can be wired together and work in tandem with your reverse lights. Two reinforced clevis mounts that take ¾-inch D-ring shackles provide recovery options during your off-road adventures.
Our high clearance Bronco bumper is constructed of 3.5mm steel plating with 5mm steel supports, and then finished in a finely textured black powder coat to protect against rust.
MTO Series Rear Bumper Features:
- Higher Than Factory Ground Clearance
- 3.5mm Steel Plates with 5mm Steel Supports
- Micro Texture Black Powder Coat
- Accepts Two, 3” Flush Mount LED Pod Lights
- Dual Clevis Mounts for ¾” D-Ring Shackles
- Retains Factory Backup Sensors
- Accommodates up to 37" Spare Tire
- Compatible with Factory Tow Hitch
- Trim Levels: Base , Big Bend, Black Diamond, Outer Banks, Badlands, Wildtrak, First Edition
This works great with any of our front bumper options, but was designed to perfectly match the style of our FS-15 Series Bronco Front Bumper.
Technical Specification:
- Fitment: Direct Fit, Ford Bronco (All Trims)
- Material: 3mm/5mm Steel
- Finish: Micro-Texture Black Powder Coat
- Weight: ≈ 76 lbs
- Lights Included: No
- D-rings Included: No
- Hardware Included: Yes
- Compatible with Factory Hitch and Sensors: Yes
- Install Time: ≈2.5hrs
High Clearance Fitment
The bumper’s mid-section sits at a higher level than the OEM bumper, and the tapered wings provide ample room for the Bronco to navigate obstacles on the trail.
Retains Parking Sensors
Sensor cut-outs allow you to install and retain full functionality of the factory rear parking sensors.
Two Flush Pod Light Mounts
Two 3” flush mounted pod lights can be installed in the bumper cutouts, and can function as supplemental trail lighting or reverse lights.
License Plate Mount with Led Light
The license plate mount was placed above the bumper and to the side of the swinging tailgate to maintain a higher clearance from obstacles. There is an included LED plate light that can be wired into the factory license plate light harness.
